Horizon Fitness CE9.2 Manuel Du Propriétaire page 7

ASSEMBLY StEp 7
WATER
BOTTLE
HOLDER
CONSOLE
MAST
BOOT
TOP CAP
(LEFT & RIGHT)
SCREWS (Z)
REAR CAP
SCREWS (Z)
REAR STABILIZER
12
CE9.2-OM-rev1.5.indd 12-13
HARDWARE BAG 7 CONTENTS :
SCREW (Z) SCREW (AA)
15 mm 20 mm
Qty: 5 Qty: 2
CONSOLE MAST
Open hardware bag 7.
A
SCREWS (AA)
Slide right and left top cap over
B
console mast and attach using 3
screws (z).
Slide console mast boot around
C
console mast and insert into top cap.
Slide water bottle holder over
D
console mast and attach using 2
screws (aa).
Slide rear cap over rear stabilizer
E
and attach using 2 screws (z).
ASSEMBLY StEp 8
CONSOLE
CONSOLE CABLES
UPPER HANDLEBAR
BOLTS (BB)
PRE-INSTALLED
SET SCREWS
CONSOLE MAST
LOWER HANDLEBAR
NOTE: Be careful not to pinch
any wires while attaching the
console or handlebars.
HARDWARE BAG 8 CONTENTS :
BOLT (BB)
12 mm
Qty: 4
A Open hardware bag 8.
B Attach the CONSOlE CABlES to the CONSOlE.
C Carefully tuck the CONSOlE CABlES into the
CONSOlE MASt before attaching the CONSOlE.
Attach CONSOlE to CONSOlE MASt using 4
BOltS (BB).
D Slide UppER HANDlEBAR onto lOWER
HANDlEBAR making sure handlebars are joined
together completely. Secure UppER HANDlEBAR
to lOWER HANDlEBAR using pRE-AttACHED
SEt SCREWS.
Make sure upper handlebars are as far down as possible.
Handlebars can be damaged If not secured correctly.
E Repeat step D on other side.
YOU ARE FINISHED!
7/21/10 9:46 AM
13