Horizon Fitness CE9.2 Manuel Du Propriétaire page 6

ASSEMBLY StEp 5
RUBBER FLAT WASHER (T)
WASHER (S) 25 mm
26 mm Qty: 4
Qty: 2
CONSOLE MAST
RUBBER WASHER (S)
LOWER HANDLEBAR
10
CE9.2-OM-rev1.5.indd 10-11
HARDWARE BAG 5 CONTENTS :
FLAT WASHER (H) SPRING WASHER (B)
20 mm 15 mm
Qty: 4 Qty: 2
Open hardware bag 5.
A
Slide 1 rubber washer (s) and 1 flat
B
washer (t) onto the console mast.
Slide lower handlebar onto console
C
FLAT WASHERS (T) mast and attach using 1 flat washer (t),
1 flat washer (h), 1 handlebar cap, 1
FLAT WASHERS (H)
flat washer (h), 1 spring washer (b)
BOLT (U)
and 1 bolt (u).
Repeat steps B–C on the opposite side of the
D
elliptical.
HANDLEBAR
CAP
SPRING
WASHER (B)
ASSEMBLY StEp 6
BOLT (U)
20 mm
Qty: 2
LOWER LINK ARM
TEFLON WASHERS (V)
HARDWARE BAG 6 CONTENTS :
TEFLON FLAT WASHER (W)
WASHER (V)
17 mm
28.4 mm Qty: 2
Qty: 4
Open hardware bag 6.
A
Align end of lower link arm with bracket on
B
bottom of lower handlebar.
Place teflon washers (v) on both sides of
C
the lower link arm. While holding teflon
NUT (Y)
washers (v) slide lower link arm into
LOWER HANDLEBAR
bottom end of lower handlebar.
FLAT WASHER (W)
Secure the joint with 1 flat washer (w), 1
D
SPRING WASHER (B)
spring washer (b),1 bolt (X) and secure
BOLT (X)
with 1 nut (y).
Repeat steps B–D on the opposite side of the
E
elliptical.
SPRING WASHER (B)
15 mm
Qty: 2
BOLT (X) NUT (Y)
70 mm Qty: 2
Qty: 2
11
7/21/10 9:45 AM