Horizon Fitness CE9.2 Manuel Du Propriétaire page 5

ASSEMBLY StEp 3
CONSOLE MAST
CONSOLE CABLE
PRE-INSTALLED BOLTS
MAIN FRAME
NOTE: Be
careful not
to pinch any
wires while
attaching the
console mast.
CRANK
PEDAL ARM
GUIDE RAIL
PEDAL ARM WHEEL
8
CE9.2-OM-rev1.5.indd 8-9
HARDWARE BAG 3 CONTENTS :
WAVY WASHER (L) BOLT (M) SPRING WASHER (B)
22.5 mm 20 mm 15 mm
Qty: 2 Qty: 2 Qty: 2
Open hardware bag 3.
A
Carefully pull the console cable through
B
the console mast using the twist tie located
inside the console mast.
C gently slide the console mast onto the
main frame and attach console mast to
main frame using pre-installed bolts.
Slide wavy washer (l) over crank
D
followed by pedal arm as shown. Rest
pedal arm wheel on guide rail.
Attach the pedal arm to the crank using 1
E
flat washer (k), 1 spring washer (b)
WAVY WASHER (L)
and 1 bolt (m).
FLAT WASHER (K)
SPRING WASHER (B)
Repeat steps D–E on the opposite side of the
F
BOLT (M)
elliptical.
ASSEMBLY StEp 4
FLAT WASHER (K)
20 mm
Qty: 2
BOLT (P)
SPRING WASHER (Q)
FLAT WASHER (R)
PEDAL ARM BRACKET
HARDWARE BAG 4 CONTENTS :
FLAT WAVY
WASHER (N) WASHER (O)
27 mm 29 mm
Qty: 4 Qty: 2
SPRING WASHER (Q) FLAT WASHER (R)
15.4 mm 20 mm
Qty: 2 Qty: 2
Open hardware bag 4.
A
Slide 1 flat washer (n), 1 wavy
B
washer (o) and another flat washer
(n) onto the lower link arm.
Slide the lower link arm into the
C
pedal arm bracket.
Attach the lower link arm to the
D
FLAT WASHERS (N) pedal arm bracket using 1 flat
WAVY WASHER (O)
washer (r), 1 spring washer (Q)
LOWER LINK ARM
and 1 bolt (p).
Repeat steps B–D on the opposite side of
E
the elliptical.
BOLT (P)
20 mm
Qty: 2
9
7/21/10 9:45 AM