Product Information; Contraindications - Dentsply Sirona Triad gel Mode D'emploi

Indications for use:
Triad Gel Material is a
visible light cure material
indicated for the fabrication
of functional orthodontic appliances,
repairs, relines and rebases.

Product Information:

Triad Gel Material is suitable
where materials with high flow
characteristics are desired, such as
when encapsulating and retaining
orthodontic wires, mesh, etc. Triad
Gel Material contains no methyl
methacrylate monomer.

Contraindications:

Triad Gel Material is contraindicated
for patients and users with
a history of allergic reaction to a)
urethane resins; and/or b) methyl
methacrylate monomer (contained in
Triad VLC Bonding Agent only).
Warnings:
Triad Gel Material and Triad
VLC Bonding Agent contain
polymerizable monomers which
may cause skin sensitization
(allergic contact dermatitis) or other
allergic reactions in susceptible
persons. Wear protective gloves and
protective clothing. Wash thoroughly
with soap and water after contact. If
skin sensitization occurs, discontinue
use. If dermatitis or other symptoms
persist, seek medical advice.
Precautions:
1. When grinding prosthodontic
resins, proper ventilation, masks
and vacuum systems should be
used.
2. Wear eye protection.
3. All cure times cited are
appropriate for Triad 2000 and
Triad II curing units. Consult
your Technical Manual or call
Technical Support for Triad I cure
times.
4. Store Triad Materials at or below
24˚C/75˚F and away from direct
sunlight.
5. Unused Triad Materials should be
polymerized prior to disposal.
Adverse Reactions:
1. Allergic contact dermatitis and
other allergic reactions may
occur in susceptible individuals.
2. Dust will be generated when
grinding Triad Materials. Eye, skin
and respiratory irritation may
occur if appropriate engineering
controls are not used.
SteP-by-SteP
InStRuCtIonS:
I. basic Functional Appliance:
1. Prepare wires, retainers, retentive
mesh, etc. in the normal manner.
Allow approximately 0.5 mm
(0.02") space between the metal
retention and the cast surface
(Figure 1A). Thoroughly clean
metal portions of appliances
by brushing with methyl
methacrylate monomer liquid
or ethyl alcohol. Allow to air dry
while the cast is being prepared.
2. Prepare the cast by applying a
1
Fig. 1A