The Manual Splitter Controls - Viscount Chorale 2 Mode D'emploi

Owner's Manual

2.2 THE MANUAL SPLITTER CONTROLS

MIDI MIDI MIDI
S
P I II
1
2
1. [S] piston: "Set" (or fix) function used for fixing combinations. To fix a combination, simply press
the [S] piston, keep it pressed and then press the combination you wish to fix.
2. [MIDI I], [MIDI II] and [MIDI P] buttons: this section contains the pistons used to activate the
transmission of MIDI note codes on the [MIDI OUT] port (in the recess underneath the first manual)
in response to the notes played on the manuals.
The LED of each piston displays the status of transmission on the relative MIDI channel as follows:
o Piston illuminated: note code transmission enabled
o Piston off: note code transmission disabled
[MIDI I] controls transmission of the notes played on the first manual, [MIDI II] controls the notes
played on the second manual, and [MIDI P] the notes played on the pedal board.
N.B.
- These pistons activate or deactivate the transmission of MIDI note codes (Note On and Note
Off) only, unlike all the other MIDI messages the organ is able to process, which are always
transmitted regardless of the status of this function.
- These pistons control transmission of MIDI notes only. Reception is always enabled.
3. [NEXT] and [PREV.] stops: general combination sequencers. [NEXT] selects combinations in
ascending order, [PREV.] in descending order.
4. General combinations: this section contains the instrument's general adjustable combinations.
When a combination is recalled, the light of the relative stop illuminates to confirm its activation.
The [NEXT] pistons can also be used to select combinations one by one in an upward direction and
[PREV.] for the same function in a downward direction (combination sequencers).
There is also a piston marked [HR] (Handle Registers) beside the general combinations; also known
as 0, when it is on it automatically memorises the register status. This piston's main function is to
restore, during use of the combinations, the "hand-made" stop setup created when the [HR] button
was on. Remember that an HR setup is not modified if the stops are switched on and off by hand when
a combination on the same section is selected (i.e. with the HR off).
PREV NEXT HR 1 2
3
Viscount
3 4 5 6
4 5
43
Chorale 2 - Chorale P31
Vivace 40
A.P ENC T
Deluxe
6
7
C
8