Viscount Chorale 2 Mode D'emploi page 55

Owner's Manual
while if you press the stop the display shows the screen shown below.
Now use the [FIELD
the cursor on the voice concerned, press [ENTER].
The top of the display contains information concerning the voice you are about to replace, while the
central part of the screen shows the possible replacement registers for that specific stop.
Here again, you can use the [FIELD
voices, which are rendered audible immediately for quicker programming by just moving the cursor over
the fields of the voices displayed.
Once you have found the voice you require, press [ENTER]:
the system now provides information about the voice to be replaced (in the top of the screen) and the new
voice (in the middle), and a prompt for confirmation to proceed, since the new register has not yet been
definitively loaded, but has simply been rendered audible for evaluation. As the display shows, press
[ENTER] to confirm the replacement or [EXIT] to abort.
If you now go ahead with the operation, the system will definitively replace the old voice and give
confirmation with the following screen:
Once replacement of the voice or voices is complete, you need to check the labels on the front panel stops
and whether they still correspond to the registers which the stops now activate. To do this, run the SOUND
CHECK function described below.
Finally, press [EXIT] to exit the function.
] and [FIELD ] buttons to select the voice you wish to replace. After locating
_PED.
Prinzipl16A
Prinzipl16B
Prinzipl16C
] and [FIELD
_PED.
Replace with:
Prinzipl16A
to confirm or Exit
_PED.
is replaced with
Prinzipl16A
Viscount
Prinzipl16C_¿
] buttons to scroll through all the replacement
Prinzipl16C _
- Enter
Prinzipl16C _
53
Chorale 2 - Chorale P31