Viscount Chorale 2 Mode D'emploi page 48

Chorale 2 - Chorale P31
Viscount
2. [MIDI] connectors: five-pin DIN connectors for connection of instruments with MIDI interface.
The [IN] connector allows receipt of MIDI data generated by remote MIDI sources, the [OUT]
connector transmits the MIDI messages generated by the Chorale, and the [THRU] connector transmits
the MIDI data exactly as received at the [IN] connector.
3. [INPUT] connectors: RCA line inputs which allow other instruments to be played using the organ's
internal amplification. If the source is monophonic use the L(MONO) connector only.
4. [OUTPUT] connectors: RCA line outputs for the unamplified signal, for connection of optional
amplified speakers, remote amplification systems or recording systems. To use a monophonic signal,
connect to the [L/(MONO)] connector only.
Left from the connection box, under the manuals of the Chorale P31, there is a switch that turns on/off the
front tweeters.
Under the keyboards on the right side you will find the stereo line in and line out sockets.
In the bottom of the rear panel there are two more pairs of line audio outputs.
The main difference between these outputs and the ones on the left is that the latter contain the signal
generated by the organ, while on the right connectors, the signals of the individual manuals and pedal
board are routed to and adjusted on the individual outputs in accordance with the relative settings on the
display (for more information see chapters 7.4 and 7.5).
5. [OUTPUT 1] and [OUTPUT 2] connectors: Jack line outputs carrying the organ signal in accordance
with the routing set by means of the function on display. With the Factory Settings active, the signals
are distributed as follows:
- [OUTPUT 1]: General signal
- [OUTPUT 2]: Reverb only
L(+R) R L(+R)
OUTPUT - 1 OUTPUT - 2
5
46
R
Owner's Manual