4.3 Tools required for assembly
Hex keys, 4mm and 5mm (provided)
Open-end wrench, 10/12mm (provided)
Cross-point (Phillips) screwdriver
4.4 Assembly
1.
Install four casters (L) to base (C) with pan head
screws (HP2). See Figure 3.
2.
Install left and right stands (D
flange head screws (HP9).
3.
Install stand support (T) to stands with flange
head screws (HP5).
Figure 3
4.
Install four casters (M) into the threaded nuts
beneath drum (F). See Figure 4.
Figure 4
,D
) to base (C) with
1
2
10
5.
Lift main housing (A) using hoist with straps
through lifting rings atop main housing. If hoist is
not available, at least 2 persons must lift housing.
Main housing is heavy. Two-
person lift, or use hoist.
6.
Position main housing (A) between left and right
stands (D
,D
), and secure with flange head
1
2
screws (HP2). See Figure 5.
Figure 5
7.
Install funnel (B) beneath main housing. Secure
with funnel clamp (G). See Figure 6. Tighten screw
on funnel clamp securely.
Figure 6