Noise Emission; Contents Of Delivery; Machine Description; Transport And Start Up - Jet JMD-45PF Mode D'emploi

Mains 400V ~3L/PE 50Hz
Output power 1,1 kW (1,5 HP) S1
Reference current
Extension cord (H07RN-F):
Installation fuse protection

4.2 Noise emission

Acoustic pressure level (EN 11202):
Idling at maximum speed 76,9 dB (A)
The specified values are emission
levels and are not necessarily to be
seen as safe operating levels.
As workplace conditions vary, this
information is intended to allow the
user to make a better estimation of the
hazards and risks involved only.
4.3 Content of delivery
Tiltable vice, jaw width 85mm
13mm drill chuck with arbour ISO-30
Face mill dia 75mm, carbide tipped
Draw bar M12
3 Down feed handles
Head rising crank and handle
3 Table hand wheels
Operating tools
Operating manual
Spare parts list.

4.4 Machine Description

Fig 1
A....Motor
B.....Z-axis ways reservoir oiler
C....Head tilting lock nuts (3x)
D....Z-axis slide lock
E....Power feed selection knob
F....Holes predrilled for digital display
G....Drill depth stop adjustment knob
H....Down feed handles
(Power feed engagement)
3.5 A
I......X-axis adjustable stops
4x1,5²
16A
J....X-axis hand wheel
K....Y-axis slide lock
L....Y-axis hand wheel
M....X-axis slide lock
N....Z-axis crank
O....Chuck guard
P....Quill lock handle
Q....Fine feed hand wheel
R.....Control box
S....Speed select lever
T.....Draw bar cover
U....Power indication light
V....ON-button
W....Stop button
X.....Emergency stop button
Y....Fw/Rev switch

5. Transport and start up

5.1 Transport and installation

The machine will be delivered in a
closed crate.
For transport use a forklift or hand
trolley. Make sure the machine does
not tip or fall off during transport.
The machine is designed to operate in
closed rooms and must be bolted to
the cabinet stand or a solid work
bench.
For packing reasons the machine is
not completely assembled.
Fig 2
3

5.2 Assembly

If you notice transport damage while
unpacking, notify your supplier
immediately. Do not operate the
machine!
Dispose of the packing in an
environmentally friendly manner.
Clean all rust protected surfaces with
petroleum, diesel oil or a mild solvent.
Screw rubber handles onto quill down
feed handle rods (H). Screw handle
rods into hub and tighten.
Slide Z-axis crank (N) onto shaft and
tighten set screw.
Install crank handle.
Slide hand wheels (J, L) onto table
hand wheel shafts and tighten set
screws.
Install handles.
Mounting machine to stand or solid
workbench.
Unbolt the lathe from the shipping
crate bottom.
Use heavy duty fibre belt for lifting the
machine off the pallet.
Caution:
The machine is heavy (340 kg)!
Assure the sufficient load capacity
and proper condition of your lifting
devices.
Never step underneath suspended
loads.
Carefully place the machine onto the
cabinet stand or a solid work bench.
Bolt together machine and cabinet
stand or workbench.
Make sure the machine cannot tip!