Operation; Switching The Device On/Off (Standby); Waiting For The Warm-Up Time; User Login - Sartorius Entris II BCA324I-1 Série Mode D'emploi

8

Operation

8 . 1 Switching the Device On/Off
(Standby)
Requirements
The device is connected to the power supply .
Procedure
NOTICE Pointed or sharp-edged objects may
t
damage the operating display! Only touch the
operating display with your fingertips .
To switch the device on: Press the [On/Off] button .
t
To switch the device to standby mode: Press and
t
hold the [On/Off] button .
8 .2

Waiting for the Warm-up Time

In order to provide accurate weighing results, the device
must have reached the necessary operating
temperature . The operating temperature is reached
after the warm-up time . The warm-up time starts when
the device is switched on .
Procedure
Switch on the device .
t
Wait until the operating temperature is reached (for
t
warm-up time, see Chapter "14 .8 Warm-up Time",
page 49) .
The warm-up time must be observed for a
conformity-assessed device, otherwise the
weight values cannot be used .
8 .3

User login

If user profiles are created: A user login is required every
time the device is switched on .
Procedure
Switch on the device .
t
1 2
Press the [Apply] button (2) .
t
If a password is assigned: The input screen for the
y
password opens .
Enter the password and confirm with the [Confirm]
t
button .
To log in a different user: Press the [On/Off] button .
t
The device is in standby mode .
y
Press the [On/Off] button .
t
The device is switched on .
y
User Management is displayed .
y
Log in a new user .
t
8 .4 Leveling the Device with an
Electronic Level Indicator
Unevenness at the installation site of the device may
result in incorrect weighing results . Leveling the balance
compensates for unevenness at the installation site by
twisting the front leveling feet of the balance .
Procedure
Follow the instructions of the Leveling Wizard .
t
8 .4 . 1

Level Indicator Test

The level indicator test is used to check the movement
of the level indicator . The level indicator must be
positioned at three different places during the level
indicator test . The level indicator is positioned by
rotating the front leveling feet .
Procedure
Open the main menu .
t
Press the "Leveling" button
t
Press "Level test" .
t
Follow the Level Indicator Wizard's instructions .
t
Entris II Advanced Line Operating Instructions
®
Operation
Press the user profile
t
selection (1) .
Select a user profile,
t
e .g ., Administrator .
39