Printing Weight Result With Id; Cleaning And Maintenance; Detaching The Frame Draft Shield And Weighing Pan; Cleaning The Device - Sartorius Entris II Advanced Line BCA Série Mode D'emploi

8 .8

Printing Weight Result With ID

Identifiers, e .g ., device ID, batch ID, and sample ID, can
be assigned to the device, the sample, and to a batch .
The ID numbers are exported during ISO / GLP printout .
Requirements
− The ISO / GLP printout is activated in the "Settings" /
"Printout" / "Manual print" / "ISO / GLP printout"
menu .
− The device ID is set in the "Settings" / "Printout" /
"IDs" / "Set device ID" menu .
− A printer or a PC is connected and configured .
Procedure
Carry out weighing .
t
Press the [Start GLP] button .
t
If the "Batch ID" function is activated: Enter a batch
t
ID .
If the "Sample ID" function is activated: Enter a
t
sample ID .
The GLP header is printed with the device ID, the
y
batch ID, the sample ID, and the current weight
value .
To exit the GLP printout: Press the [Exit GLP] button .
t
The GLP footer is printed .
y
9 Cleaning and
Maintenance
9 . 1 Detaching the Frame Draft
Shield and Weighing Pan
Requirements
The device is disconnected from the power supply .
Procedure
Remove the
t
1 weighing pan (1),
the four shock
2
absorbers (2), and
3 the frame draft
shield (3) .

Cleaning and Maintenance

9 .2

Cleaning the Device

Procedure
Disconnect the device from the power supply .
t
Only use suitable cleaning agents and cleaning
t
procedures and observe the product information for
the cleaning agent used (for cleaning agent, see
Chapter "14 .7 Cleaning Agent", page 48) .
Remove dust and powdery sample residue with a
t
brush or hand-held vacuum cleaner .
Wipe the device and the associated components
t
with a slightly damp cloth . Use a mild soapy solution
or a suitable cleaning agent for more severe
contamination .
9 .3 Attaching the Frame Draft
Shield and Weighing Pan
Procedure
Put the frame draft shield, the four shock absorbers,
t
and the weighing pan into place .
Connect the device to the power supply (see
t
Chapter 6.2, page 35).
9 .4

Maintenance Schedule

Interval Component
Regularly; Device
depending on
the operating
conditions
9 .5

Software Update

For a software update, contact Sartorius Service .
Entris II Advanced Line Operating Instructions
®
Action
Perform a
functional test of
the device .
Contact Sartorius
Service for this .
41