Step By Step Procedures - Ksenia lares wls 96-IP Manuel D'installation

Scenarios: for the explanation of the parameters refer to the homonymous section of the configura-
tion menu.
Prog. Thermostat: In this menu you can enable the Thermostat. Its configuration is made via user APP
for mobile devices
Phone book : for the explanation of the parameters refer to the homonymous section of the configu-
ration menu.
Voice messages: The control panel has in its configuration a set of default voice messages. From this
option you can listen to or customize the voice messages that will be played in sending a voice call.
For more details refer to the STEP-BY-STEP PROCEDURES
SIM options: for an explanation of the parameters refer to the homonymous section of the configura-
tion menu.
Codes : for the explanation of the parameters refer to the homonymous section of the configuration
menu.
Tags: In this section, you can scan the RFID keys, change or delete a configured one
EN
Partitions: for an explanation of the parameters refer to the homonymous section of the configuration
menu.
Partials: for an explanation of the parameters refer to Partitions section of the configuration menu.
Network setting: In this field you can view the IP address associated to the control panel and possibly
enable DHCP.
Language: In this menu you can change the keypad language
Time zone: In this menu you can set the time zone
Summertime conf.: In this menu you can change or enable automatic management of the transition
summer / winter time
CID protocol: In this menu you can set the options for the CID receivers.
To better understand what is written below is recommended that you first read the section related to
the features of the system and the one related to the structure of technical and programming menu
NOTE: After the programming of wireless devices, before performing the functional tests, wait that
each wireless device has been reconfigured by the control panel. Reconfiguration takes place
through a transmission by the wireless device to the control panel carried out after exiting the pro-
gramming. Waiting for 15 minutes is sufficient to ensure the alignment of all the wireless devices to the
new programming. The installer can in any case force the transmission of the various wireless devices,
thus avoiding the need to wait.
The addition of a new wireless device can be performed by entering the menu of programming and
positioning on the option of device to be scanned. Press one first time the ENTER key to get to the
option "Enroll". Press the ENTER key again to let the control panel access the acquisition phase. At this
point the central waits to receive a signal from the radio device. To know how to force the corre-
sponding signal for different wireless devices, refer to the respective manual. Once the programming
of the device is successful, the keypad display will show the name and serial number. For example, if
you want to add a magnetic contact, move the option "Wireless Sensors "and press the ENTER key.
This lead to "Enroll". Press ENTER again to let the control panel access the acquisition phase. Now
insert the battery on the device and close the cover. The keypad display will show the name and
serial number of the newly registered device. At this point, pressing the ENTER key, it is possible to enter
the sub menu of device configuration. Conversely, pressing the ESC key, the configuration phase is
postponed and you can continue the acquisition of other devices.
The cancellation of a wireless device can be performed by entering the configuration menu of the
device you want to delete, positioning on the option "Delete" and confirming by pressing ENTER.
52

STEP BY STEP PROCEDURES

PROCEDURE TO ADD A WIRELESS DEVICE
PROCEDURE TO DELETE A WIRELESS DEVICE