CONTROL PANEL CONFIGURATION
When delivered, the 'lares wls 96-IP' Control Panels is has to be programmed on purpose.
In general it is possible to proceed as follows:
• Assign, remove and program the various parameters of the different wireless peripherals
• Configure all inputs and outputs available on the Control Panel
• Program the actions to be executed according to the activated scenario
• Modify the Installer and User codes
• Configure the proximity Keys (mini-Tags)
• Insert or modify the phone-book numbers
• Record and listen the Voice Messages
• Configure all main system options.
The configuration can be done choosing one of the following modes:
1. remotely, thanks to the APP 'SecureWeb' available for iOS and Android
EN
2. remotely, through the portal : www.kseniasecureweb.com
3. through webserver, accessing in local mode or peer-to-peer to the Panel
4. using the Keypad, either the one incorporated or a remote-one but linked to the BUS.
In general, all configurations can be done just by choosing one of the mode listed above, there
could be minor exceptions explained in the relevant sections.
NOTE:• the default Installer PIN to access the configuration is 123456
• the access to 'Technical Menu' of configuration is NOT possible if the System is armed stay or
away, or if it has specifically been blocked by the User.
1) REMOTE APP CONFIGURATION: download the APP named 'SecureWeb' for any mobile device
available on AppStore or PlayStore. Login to the APP using the same credentials used to get access
to our 'Reserved Area' on the site www.kseniasecurity.com, in case of Installers not yet registered, you
must then register on the above site.
The registration is strictly personal and allows to configure an unlimited number of Panels.
Once the APP is opened, it is sufficient to enter into the Tab called 'Devices', here all Panels are listed
and in communication with you.
To configure a new Control Panel, press on + (top-right) , scan the QR-code present on the PCB label
or insert manually the 16 digits serial number .
2) REMOTE PORTAL CONFIGURATION: It uses the service Ksenia SecureWeb, through the portal:
www.kseniasecureweb.com, reserved to the Selected Ksenia Installers. The access is allowed by using
the same credentials used to get access to our 'Reserved Area' on the site www.kseniasecurity.com,
in case of Installers not yet registered, you can then register directly on the Portal.
The registration is strictly personal and allows the configuration of an unlimited numbers of Panels.
Once logged on the portal, it is sufficient to enter into the section 'Devices' and you find the list of
all Panels already in communication with you. To configure a new Panel, insert 16 digits serial number
that you'll find on the PCB label and click 'Register new panel'.
3) WEB SERVER CONFIGURATION: Locally accessing the webserver configurator. The Panel starts by
default with enabled DHCP, then there are 2 possibilities to find out the IP Address:
by the Keypad, entering the dedicated 'technical menu' or using the server named:
https://KS-BOARD-xx-yy-zz (replacing the xx-yy-zz with the last 6 digits of the MAC Address printed
on the label). In case the network programmed will not support the DHCP, the default address is
https://192.168.2.96.
4) KEYPAD CONFIGURATION : to start this configuration mode is necessary to digit on the KP the 6 digit
Installer code. Once inserted the right PIN, you'll have access to the 'technical menu' from which
You can proceed with the configuration or verify the Sensors Status, the eventual faults or the whole
System Status.
43