Salter Nutri-Weigh Slim Mode D'emploi page 3

NOTE: The Aquatronic® liquid measure feature is suitable for all water based liquids, including wine, milk, stock,
cream etc. Please be aware that oils have a lower specific gravity, which will result in a volume reading of approx.
+10%. If measuring oils by volume on this scale, please adjust for this accordingly.
TO WEIGH:
1) Press and release the ON/OFF key to turn the scale on
2) Wait until display shows 0.0
3) Place item to be weighed on the platform
4) Weight is displayed
TO ADD & WEIGH:
To weigh several different ingredients, press the ZERO key to reset the display between each ingredient.
NOTE: When weights have been tared out, the display will show a negative number when the items are removed
from the scale. To reset the scale back to zero for a new measurement, press the ZERO button.
TO DISPLAY NUTRITIONAL READINGS:
1) Press and release the ON/OFF key to turn the scale on
2) Place food item to be weighed on the platform.
3) Clear the food code if necessary by pressing and releasing the CLR key – the food code 000 is displayed.
4) Refer to the table in this manual and identify the 3 digit code for the food item being weighed
(e.g. 921 for honey).
5) Using the numerical keys (0 – 9) enter the 3 digit code
6) When the 3rd digit is pressed, the values for calories, salt, protein, fat, carbohydrates, cholesterol, and fiber for
the food item will all appear on the screen.
TO SAVE NUTRITIONAL VALUES TO MEMORY:
1) Follow steps 1 – 6 of the 'To Display Nutritional Readings' section.
2) Press M+ key to add the food item being weighed to memory.
3) M01 will be shown at the upper left corner of the display to indicate that one set of values has been saved to
memory. To add additional food items to memory, repeat the previous steps.
NOTE: The memory is saved permanently, even if the scale is switched off except when the batteries are removed.
NOTE: The maximum number of food items that can be added to the memory is 99.
When the memory number reaches 99 the display will flash "99" – the memory must be cleared by following the
instructions in the 'To Clear Memory' section.
TO RECALL MEMORY:
1) Press MR key to see the total values for all of the food items stored to memory.
2) Σ is displayed next to the memory indicator to indicate that the total memory is being displayed.
3) The total values for calories, salt, protein, fat, carbohydrates, cholesterol, and fibre for the food items stored in
memory will all appear on the screen.
NOTE: It is not possible to display the total weight of the food items stored to memory.

TO CLEAR MEMORY:
1) Press the MR key.
2) Press the MC key.
3) The memory is cleared when the memory indicator and memory number are no longer displayed.
NOTE: the scale can only store up to 99 foods in memory. If over 99 items are stored, the display will flash "99".
Press MC to clear the memory.
FUNCTION KEYS:
ON/OFF Switch scale on/off
ZERO Set weight to zero
M+ Save nutritional values to memory (up to a maximum of 99 values)
MR Recall the total nutritional values stored in memory
CLR Clear food code
MC Clear memory
UNIT Convert between g/oz/lb:oz/ml/fl.oz
NUTRITION KEYS:
cal Calorie content (cal) carb
salt Salt content (mg) chol
prot Protein content (g) fibr
fat Fat content (g)
WARNING INDICATORS:
Replace battery
Weight overload
Nutritional value exceeds
maximum display limit
NOTES FOR CLEANING/CARE:
Clean the scale with a slightly damp cloth.
DO NOT immerse the scale in water or use chemical/abrasive cleaning agent.
Carbohydrate content (g)
Cholesterol content (mg)
Fiber content (g)