Maintenance And Repair; Cleaning; Battery Replacement - Amprobe TIC 300 PRO Mode D'emploi

MAINTENANCE AND REPAIR

If there appears to be a malfunction during the
operation of the voltage detector, the following steps
should be performed in order to isolate the cause of the
problem:
1. Check the battery.
2. Review the operating instructions for possible
mistakes in operating procedure.
Except for the replacement of the battery, repair of
the voltage detector should be performed only by a
Factory Authorized Service Center or by other qualified
instrument service personnel.

Cleaning

The front panel and case can be cleaned with a mild
solution of detergent and water. Apply sparingly with a
soft cloth and allow to dry completely before using. Do
not use aromatic hydrocarbons or chlorinated solvents
for cleaning.

Battery Replacement

Use a Phillips blade screwdriver to remove the battery
hatch screw. Lift the hatch. Remove the battery and
replace it with a 9 V alkaline battery. Make sure the seal
is in place. Close the battery hatch and replace the screw.
9