Safety - John Bean B 2000P Manuel D'utilisation

Safety

.. ..........
_
1.0 SAFETY
Important safety precautions relevant to the unit are
described in the Safety Booklet, refer to Figure 1 – 1.
The Safety Precautions should be fully understood and
observed by every operator. We suggest you store (a
copy) of the Safety Booklet near the unit, within easy
reach of the operator.
The Operator's Manual will contain specifi c warnings
and cautions when dangerous situations may be
encountered during the procedures described.
It should be noted that working with technical
equipment may always involve an unforeseeable
acceptable risk. Therefore the operator should
eliminate such dangers by operating the machine
with care.
The following points should be observed:
use the machine only as a technical work tool for its
specified scope of application only;
always use original accessories, approved by the
P/N: EAZ0033G02A
manufacturer, in perfect condition and suitable for
the type of work to be carried out;
follow the instructions, notes and technical data of
1-1
the machine manufacturer and the manufacturer of
the wheels to be balanced;
wear suitable protective clothing and accessories
(e.g. goggles, safety shoes, etc.);
avoid eye contact with the Laser Systems;
do not knock or camper the Laser Systems;
do not rest on the wheel guard whilst the run is in
progess.
In case of calibration defects there is an internal
diagnostic that prompts contacting service.
WARNING:
ONLY THE OPERATOR CAN WORK AND MOVE
WITHIN THE WORKING AREA.
Do not allow unauthorized people in the work area.
min.
500 mm
min. 2200 mm
8