Troubleshooting; General; Troubleshooting Table - ETNA KI2160ZT Mode D'emploi

TROUBLESHOOTING

General

If you notice a crack in the glass top (however small), switch the hob off immediately, unplug
the hob or turn off the (automatic) fuse switch(es) in the meter cupboard or. In the event of a
permanent connection, set the switch in the power supply lead to zero. Contact the service
department.

Troubleshooting table

If the appliance does not work properly, this does not always mean that it is defective.
Try to deal with the problem yourself first by checking the points mentioned below or check for
more information the website 'www.etna.nl'.
Symptom
The display lights up when
the hob is activated for the
first time.
The fan runs on for several
minutes after the hob has
been switched off.
A slight smell is noticeable
the first few times the hob
is used.
The pans make a noise while
cooking.
You have switched on
a cooking zone, but the
display shows 'u'.
The hob suddenly stops working.
The displays show '--' or 'H'.
A cooking zone suddenly
stops working and you hear
a signal.
The hob is not working
and nothing appears in
the display.
A fuse blows as soon as the
hob is switched on.
Possible cause
This is the standard set-
up routine.
The hob is cooling.
The new appliance is
heating up.
This is caused by the energy
flowing from the hob to the
saucepan.
The pan you are using is
not suitable for induction
cooking, or has a diameter
of less than 12 cm.
The control panel is dirty or
there is an object on it.
The preset time has ended.
There is no power supply
due to a defective cable or
a faulty connection.
The hob has been wrongly
connected.
Solution
Normal operation.
Normal operation.
This is normal and will
disappear once it has been
used a few times. Ventilate
the kitchen.
At high settings this is
perfectly normal for some
pans. It will not damage either
the pans or the hob.
Use a suitable pan.
Clean the control panel.
Remove objects, moisture
or dirt.
Switch off the bleep by
touching the + key of the
timer.
Check the fuses or the electric
switch (if there is no plug).
Have the electrical
connection checked.
EN 17