Troubleshooting; General; Troubleshooting Table - ETNA KIV154RVS Mode D'emploi

TROUBLESHOOTING

General

Troubleshooting table

Symptom
The fan runs on for several
minutes after the hob has been
switched off.
A slight smell is noticeable the
first few times the hob is used.
You can hear a ticking sound
in your hob.
The pans make a noise while
cooking.
You have switched a cooking
zone on but the display keeps
flashing. A pan detection
symbol (U) will appear in
the display.
When cooking, its seems as
if the zone continuously goes
on and off (the contents of the
pan boil, stop boiling, return to
the boil, etc).
If you notice a crack in the glass top (however small), switch the hob
off immediately, unplug the hob, turn off the (automatic) fuse switch(es)
in the meter cupboard or, in the event of a permanent connection,
set the switch in the power supply lead to zero. Contact the service
department.
When in doubt on the proper operation of your appliance, this does
not automatically mean there is a defect. Try to address the problem
yourself first by checking the points mentioned below or for more
information visit the 'www.etnaservice.nl' website.
Possible cause
The hob is cooling down.
The new appliance is
heating up.
Ticking can also occur at
lower settings.
This is caused by the energy
flowing from the hob to the
saucepan.
The pan you are using is not
suitable for induction cooking
or has a diameter that is
too small.
This is the 'switching' of the
power: the cooking zone is
on, but the power switches
on and off.
Solution
Normal operation.
This is normal and will
disappear once it has been
used a few times. Ventilate
the kitchen.
Normal operation.
At high settings this is
perfectly normal for some
pans. It will not damage
either the pans or the hob.
Use a correct pan.
Normal operation; this is
a feature of this induction
hob (see 'Switching of the
power').
EN 17