AVG AVO-308CS2-OREGON Instructions D'installation Et Guide De L'usager page 32

OPERATING THE HOOD (continued)
Controls (continued):
• Adjusting the timer function:
• While the blower is not running, press and hold Decrease (‐) button over 3 seconds to enter
timer mode. Adjust to desired time by pressing Increase (+) or Decrease (‐) button (for a
minimum of 1 minute to a maximum of 9 minutes). This setting will be saved i
• Activating the timer function:
• While the blower is running, press and hold Power button for over 3 seconds to activate
Power‐off Delay Digital Timer. The Power‐off delay indicator will light up and the Power‐off
delay digital timer will begin to countdown; when it reaches zero, the blower will shut down.
• Adjusting the light:
• Press Light button once to turn lights on and once again to turn lights off.
• While the lights are off, press and hold the Light button for over 3 seconds to adjust the
intensity of the lights. The level of brightness will be stored in system's memory.
CAUTION: DO NOT touch the lights until switched OFF and cooled.
Note:
Light settings are independent from other settings (including power‐off delay) and lights have to be
manually turned on or off.
Note:
The system saves user configurations. Settings such as light, timer and blower speed will remain the same
the next time it is turned on.
32
mmediately.