AVG AVO-308CS2-OREGON Instructions D'installation Et Guide De L'usager page 30

INSTALLING THE UNIT (continued)
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Step 6: Install both chimneys and tighten screws to secure the
lower chimney to the range hood as shown in Figure 5
Step 7: To avoid scratching the chimney, extend the upper
chimney slowly and carefully to the chimney‐mounting
bracket and tighten screws as shown in Figure 6.
NOTE: Remove the protective plastic film covering the top
chimney cover and the hood.
Step 8: Insert the oil tunnel (see figure 7).
:
Step 9 To install the filters, refer to Figure 8 by following the
steps below:
1. Point the filter toward the rear of the hood.
2. Push the filter until it is level.
3. Slide forward in the check mark on the front of the
hood.
4. Lower the filter.
5. Slide back until it snaps into place.
:
Step 10 Turn power ON in control panel. Check all lights and fan
functions.
30
.