Cleaning And Maintenance; How To Proceed - Sinmag Europe SM 520S Mode D'emploi

4. CLEANING AND MAINTENANCE

CAUTION Always switch off and disconnect power to the machine before
opening end covers.
This machine has been designed for simple cleaning and easy sanitation
compliance. If you regularly and properly the service machine, it will remain in
good working order.
4.1. Dismantling conveyor belt
• Take off the machine table.
• Turn the two hand nuts to release tension on the belt using tool
provided.
• Remove belt from table.
• Cleaning conveyor belts
Belts must only be brushed clean when they are dry. Never clean belts when
they are wet.
Regulating tension of conveyor belts
• Before operating the machine always see to it that the belt tension is
properly regulated by appropriate adjustment of the hand nuts.
• Run the machine from left to right.
• The belts must always track straight. If a belt tends to run to one side, the
tension on that side must be increased, or the hand nuts on the opposite
side slackened off. Use nut tensioning tool provided.
• Run machine from right to left and regulate the same way.
• Do not stretch conveyor belts too tightly.
NOTE: By setting maintaining belts at the correct tension, you will greatly
extend belt service life.
4.2.

How to proceed

1
1.
Remove the two bolts on the side covers on both sides of the machine.
2.
Unscrew the shaft bolt a bit.
2 3
SINMAG EUROPE BVBA
ENG
4
7