Sinmag Europe SM 520S Mode D'emploi page 5

2. Attach the two conveyor table support brackets and screw tightly.
3. Push locking collar, located at the spring loaded conical bolt, tightly against
machine head. Then tighten two set screws.
2
4.
Have the table rest on the supporting frame.
3.4. Detaching and attaching the scrapers
A. Attaching top scrapers
• Place scraper on top pressing roller.
• Pull out the spring - mounted retaining levers far enough to allow
angle to slide underneath.
• Position retaining levers to engage the scraper.
B. Detaching top scraper
• Lift up retaining levers to allow scraper to come away.
C. Attaching bottom scraper
• Place the t-scraper with the hooks pointed downwards in the
space between the pressure and conveyor rollers.
• Pushdown t-irons as far as they will go into the lateral guides.
• Fix spring-mounted rods under rolling table into the hooks.
D. Detaching bottom scraper
• Reverse procedure described in C.
3
SINMAG EUROPE BVBA
ENG
5