Sinmag Europe SM 520S Mode D'emploi page 4

ENG
NOTE:
Before making any electrical connections, be sure that your electrical
supplysystemiscompatiblewiththeelectricalspecificationsofyourreversible
dough sheeter.
Thestandardspecificationsare:3Phase,50Hertz,8.0Amps.
The reversible dough sheeter is equipped with a factory installed six foot pow-
er cord. The sheeter is also equipped with a rotary ON/OFF switch actuates
a contactor with thermal and magnetic overload protection to disconnect the
motor automatically in the event of an electrical overload or malfunction. To
reset, turn the switch to the ON position.
3. OPERATION INSTRUCTIONS
3.1. Setting roller clearances
Depress locking lever on handle of roller adjustment lever. Turn roller adjust-
ment lever to alter position of top pressure roller. The scale dial indicates the
value of the roller clearance setting.
3.2. Dough thickness stop control
• Set the adjustment lever to the desired thickness.
• Undo the knurled knob and move the sliding block until it comes up against
the lever.
• Tighten up the knurled knob.
3.3. Attaching and detaching of the conveyor tables
Two persons will be necessary to have the machine properly installed.
1. Press the table against the conical bolt on the roller mounting until the
CONE on the opposite side of the machine engages.
The DRIVING LUG must catch in the coupling bolt.
4
SINMAG EUROPE BVBA