General - ETNA T007VB Serie Notice D'utilisation

General

The fitting of the appliance should only be
carried out by a registered Corgi gas fitter.
This appliance conforms to current CE
guidelines.
Please note:
This appliance is not connected to a flue duct.
Take care to ensure that there is sufficient
ventilation.
Electrical connection
230 V - 50 Hz.
■ The electrical connection must comply with
national and local regulations.
■
Wall socket and plug must be accessible at
all times.
■ If you want to make a fixed connection,
ensure that a multi-pole switch with a
distance between contacts of 3 mm is
installed in the supply cable.
Gasconnection RC 1/2˝ (ISO 7/1-RC 1/2)
■ The gas connection must comply with
national and local regulations.
Amongst other things these regulations
instruct that:
– only approved materials are to be used;
– only a completely metal hose may be used
behind a built-in oven and beneath the hob.
Please note:
The type of gas and the country for which the
appliance has been designed are indicated on
the data badge.
■ We recommend that the hob be connected by
means of a fixed pipe. Connection using a
specially designed safety hose is also
permitted. In all cases the connection tap for
the appliance must be positioned such that it
is easily accessible, in an adjacent kitchen
cupboard, for example.
Please note:
A metal safety hose must not get kinks in it or get
trapped and must not come into contact with
moving parts of the kitchen furniture.
■ Before using the appliance for the first time
check the connections using water and
washing-up liquid to ensure that there are no
gas leaks.
■
Do not install a hob next to a high cupboard
or wall made of flammable material. (If there
is no alternative, ensure that there is a
minimal distance of 150 mm between the
outer edge of the hob and the wall in
question. Also ensure that there is a minimum
distance of 650/750* mm between the hob
and any overhead extractor fan which may be
See also picture 4
installed.)
* 750 mm if the hob is fitted with a wok
burner