Disposal Of Packaging / Appliance; General - ETNA T265 Notice D'utilisation

Disposal of packaging / appliance

n the manufacturing of this appliance use has
been made of durable materials. At the end of
its lifecycle this appliance must be disposed
of in a responsible manner. The authorities
can advise you on this.
The appliance packaging is recyclable. The
following may have been used:
- cardboard;
- polythene film (PE);
- CFC-free polystyrene (PS hard foam).
Dispose of these materials responsibly and in
accordance with government regulations.

General

This appliance meets all relevant CE
guidelines.
The data plate on the underside of the
appliance indicates the total nominal load, the
required voltage and the frequency.
Safety
This appliance should only be connected up
by a registered electrical installer!
The electrical connection must comply with
national and local regulations.
The appliance should always be earthed.
Damage caused by incorrect connection,
incorrect use or incorrect building in is not
covered by the guarantee.
For correct operation of the appliance it is
important that:
the power cable hangs freely and is not
struck by a drawer;
the worktop is level.
The walls and the worktop around the
appliance must be made of heat-resistant
(>85°C) material. Even if the appliance itself
does not get hot, the heat from a hot frying
pan, for instance, could cause discolouring or
damage to the wall or worktop.