Channel Search (Scan Mode); Selecting A Call Tone - switel WT370 Mode D'emploi

3.11 Channel search (scan mode)

When channel search (scan) is switched on, all 8 channels are
continuously polled until the radio finds a channel that is being used for
speech. Even if other radios are speaking on one of the 38 call codes,
the radio is found channel. If the call code should not agree with your
settings, you must adjust these by hand.
1. Press the MODE button three times. The
in the display.
2. Channel search is switched on with the
off with the
3. Confirm the selection with the talk button on the left-hand side.
4. All channels will now be scanned one after the other. As soon as a
channel is found that is currently in use, channel search will be
interrupted for 2 seconds. Press the TALK button during this time if
you want to keep the channel that has been found and exit the
channel search. Channel search can be switched off at any time
with the MODE button.

3.12 Selecting a call tone

You can transmit a call tone to the other radios using the call button
(see 3.5) when you want to begin a call. 10 different melodies are
available.
1. Press the MODE button four times. The CA TONE indicator will
flash in the display.
2. Select the required call tone between 1 and 10 using the
buttons.
3. Confirm the selection with the talk button on the left-hand side.
- Operation -
button.
indicator will flash
button and switched
and
55