Fitting Or Remove The Belt Clip; Connecting The Charging Station; Charging The Radios; Wall Mounting - switel WT370 Mode D'emploi

2.3

Fitting or remove the belt clip

To remove the belt clip, pull gently on the upper tab (B)
and slide the belt clip upwards.
Slide the belt clip from above onto the guide (A)
until it audibly snaps into place.
2.4 Connecting the charging
station
Insert the plug of the power supply into the socket on the charging
station and plug the power supply into a properly installed 230 V mains
socket. For safety reasons, use only the plug-in mains power supply
provided.
2.5

Charging the radios

The rechargeable batteries for the two radios have a stand-by time of
max. 66 hours at room temperature and a maximum period of use of up
to 22 hours. The current battery capacity is shown in the display.
To charge, place the radios in the charging station for ca. 12
hours.
full
2.6

Wall Mounting

The charging station is also suitable for
wall mounting. Use two screws for fixing
it to the wall. Drill two holes 72 mm apart
and leave the screws protruding 4 mm
from the wall. Now place the charging
station over the screws and push down
slightly.
48
- Commissioning -
half full batteries are
discharged.
72mm