Fitting The Belt Clip; Connecting The Charging Station; Charging The Radios - switel WT227 Mode D'emploi

2.3

Fitting the belt clip

After you have installed the batteries, you can fit the belt clip supplied
with the unit. Slide the belt clip into the guide from above until it
audibly engages. To remove the belt clip again, pull the fixing strap up
slightly using your finger nail and push the belt clip upwards.
2.4

Connecting the charging station

Insert the plug of the power supply into the socket on the charging
station and plug the power supply into a properly installed 230 V
mains socket. For safety reasons, use only the plug-in mains power
supply provided.
2.5

Charging the radios

The rechargeable batteries for the two radios have a stand-by time of
max. 49 hours at room temperature and a maximum period of use of
up to 18 hours. The current battery capacity is shown in the display.
To charge, place the radios in the charging station for ca. 12
hours.
48
- Commissioning -
half full
full
batteries are
discharged.