Tunturi Pure Cross R 4.1 Mode D'emploi page 6

• Fit front stabilizer by using the shown
hardware.
Remark:
First put all screws/ bolts in correct place
before tightening them fully.
Assembly step B
• Fit height adjustment pads to the rear
stabilizer.
• Fit rear stabilizer by using the shown
hardware.
Remark:
First put all screws/ bolts in correct place
before tightening them fully.
Assembly step C
•
• Connect the wires from upright tube
and main frame before sliding the
upright tube in position.
Remark:
Do not remove screws from the frame
before siding the upright tube in position.
6
• Use the enclosed Allen key to tighten
both fastening screws through the
holes in the tube from inside out.
• Tighten the fastening screws by
turning them counter-clockwise.
Remark:
First tighten all 6 bolts hand tight before
tightening them fully. This to avoid miss
alignment
Assembly step D
• Push the metal shaft through the
bracket housing of the left arm.
Attach now the left arm to the front
frame tube by pushing the metal
shaft through the opening in the tube.
Push the right arm on the shaft and
lock it by tightening a large washer,
and a screw to the both ends of the
shaft. Tighten the arms using two
Allen keys.
Remark:
A think shim washer is in between both
swivel arms and front frame tube..
• Fix the bottle holder to the upright
tube.