Cleaning And Maintenance; Transport And Storage; Disclaimer; Warranty - Tunturi Pure Cross R 4.1 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Press "Recovery" to start recovery
program.
Note:
Recovery mode requires heart rate
reading
Cleaning and
maintenance
Defects and malfunctions Despite
continuous quality control, defects and
malfunctions caused by individual parts
can occur in the equipment. In most
cases, it will be sufficient to replace the
defective part.
If the equipment does not function
properly, immediately contact the
dealer.
Provide the model number and the
serial number of the equipment to
the dealer. State the nature of the
problem, conditions of use and
purchase date.
18
Transport and
storage
WARNING
Carry and move the equipment with at
least two persons.
Remain standing in front of the
equipment on each side and take a
sturdy grip at the handlebars. Lift the
front of the equipment so as to lift the
rear of the equipment on the wheels.
Move the equipment and carefully
put the equipment down. Place the
equipment on a protective base to
prevent damage to the floor surface.
Move the equipment carefully over
uneven surfaces. Do not move the
equipment upstairs using the wheels,
but carry the equipment by the
handlebars.
Store the equipment in a dry place
with as little temperature variation as
possible.

Disclaimer

2014 Tunturi New Fitness BV.
All rights reserved
The product and the manual are subject
to change. Specifications can be
changed without further notice

Warranty

The product has a warranty from the
date of delivery (to be documented by
invoice or delivery note).
Further information on warranty terms
can be obtained from your local dealer.
The warranty terms may vary from one
country to another. Damages caused by
normal wear, overloading or improper
handling are excluded from the warranty.
Damages caused by material or
manufacturing faults are covered by the
warranty and will repaired or replaced at
no cost.

Publicité

Table des Matières
loading

Table des Matières