User Manual
3.4 ADJUSTING THE VOICE VOLUME
It is possible to adjust, for each organ style, the volume of each single voice, classical and orchestral. To do
so, follow this procedure:
1.
While holding down the [SET] button, press [MEMORY]. To indicate the beginning of the
adjustment procedure, the LEDs of the registers flash twice after which the LEDs of the
[MEMORY] button begin to flash.
2.
Turn on the voice whose volume you want to adjust. The seven LEDs of the [TRANSPOSER]
button indicate the seven dB volume levels: from left to right -6, -4, -2, 0, +2, +4, +6. When a
voice is turned on, its LED starts flashing.
3.
Other voices can also be switched on, so that changes can be evaluated as a whole. In this case,
keep in mind that the voice you are adjusting the volume is the one whose register flashes.
4.
When playing on the keyboard, press [TRANSPOSER] to cycle through the seven levels.
5.
Press the [MEMORY] button to complete and store the adjustment operation.
3.5 ADJUSTING THE TREMOLO
Using the [TREMULANT] tab you can enable and disable the Tremolo effect for Manual II voicess.
The depth and speed of the sound modulation produced by the Tremolo can be adjusted, for each organ
style. To do so, follow this procedure:
1.
While holding down the [SET] button, press [MEMORY]. To indicate the beginning of the
adjustment procedure, the LEDs of the registers flash twice after which the LEDs of the
[MEMORY] button begin to flash.
2.
Turn on one or more Manual II voices with which you want to adjust the tremolo.
3.
Turn on the Tremolo. The seven LEDs of the [TEMPERAMENT] button indicate the
modulation speed of the effect, while the LEDs of the [TRANSPOSER] button indicate the
modulation depth.
4.
When playing on the keyboard, press the above buttons to adjust the modulation speed and/or
modulation depth.
5.
Press the [MEMORY] button to complete and store the adjustment operation.
3.6 SELECTION OF ORCHESTRAL VOICES
Chorum 10 has 14 orchestral voices. These can be associated with the five ORCHESTRA buttons (two
for Manual I and three for Manual II). The orchestral voices that you can play are:
- Piano
- Harpsichord
- Celesta
- Bells
- Harp
For each [ORCHESTRA] button you can associate the desired voice. To do so, follow this procedure:
1.
Press and hold the [SET] button and press the [ORCHESTRA] button you want to change the
voice.
2.
Each time you press, a new voice is selected from the list above. The voice change is confirmed by
the flashing of the corresponding LED.
3.
Release the [SET] button to complete and store the adjustment operation.
- Strings
- Strings with slow attack
- Man's Choir
- Gregorian Choir
- Trumpet
EN - 8
Chorum 10 Dlx – Chorum S10
- Oboe
- Clarinet
- Flute
- Pan Flute