Lumie Bodyclock STARTER 30 Notice D'utilisation page 5

English
seconds.
Wake-up options
You can wake to a sunrise followed by an alarm beep. This also adds
a snooze feature.
Press and hold E until S shows, then press E repeatedly until F
flashes.
Press - or + to select either beep Y or beep X. To set, press E or
wait 12 seconds.
Press E to turn off the alarm sound in the morning.
Snooze
To snooze, instead of turning off the alarm, press and hold - to grab
another nine minutes in bed before the alarm goes off again.
Note: If you don't turn them off yourself, the light and the audible alarm
turn off automatically after 30 minutes.
Display brightness
You can set the brightness of the display panel to automatically dim
to minimise sleep disturbance. When you activate your wake-up
sunrise before going to sleep this feature is also activated (see also
Waking up without a sunrise).
Press and hold E until S shows, then press E repeatedly until all
three FA Q symbols flash.
Press - or + to select either V or Z.
V causes the display panel to dim to a low level when the light is
low or off. The display reverts to normal brightness during the
wake-up sunrise.
Z causes the display panel to dim to a low level then finally off
when the light is low or off. The display reverts to normal brightness
during the wake-up sunrise.
To set, press E or wait 12 seconds.
Tip: If you need to see the time when the display is dim or off, press
+ to light the display panel. After 12 seconds it reverts to its
8 | www.lumie.com
English
previous low level.
Frequently asked questions
What happens when I unplug my Bodyclock Starter or there's a
power cut?
Your Bodyclock Starter keeps time for one hour; other settings are
permanent, so you won't need to reprogram the unit, just plug it
back in. If you need to adjust the time, see
The display panel is too bright when I'm trying to sleep; how
can I change it?
See Display brightness for auto-dimming options.
What can I do if the display is working but the light doesn't
come on?
Check to make sure the bulb is firmly screwed into the socket. If this
doesn't work, replace the bulb.
How do I restore the default factory settings?
Turn off the power at the mains. Press and hold E as you turn the
power back on. Release the button when the software version
number shows.
What can I do if neither the display nor light are working?
A fuse may have blown. With the unit unplugged, try replacing the
3A fuse in the plug.
Please contact Lumie if you need a replacement bulb or if you still
have a problem with your Bodyclock Starter.
Clock and alarm time.
www.lumie.com | 9