Bresser 4Cast NG Mode D'emploi page 38

˚C
˚C
˚C
CHANNEL AUTO-SCAN DISPLAY
• Press the [CHANNEL] button, until the
channels. The measurements from each channel will be displayed alternatively in 5-second inter-
vals.
NOTE: The channel auto-scan feature can only be activated if there is more than one outdoor
sensor operating and each is set to a different channel.
MAXIMUM AND MINIMUM RECORDED TEMPERATURE AND HUMIDITY
• The maximum and minimum recorded indoor and outdoor temperature and humidity will be
s
automatically stored in the memory of the main unit. If you press the [MEM] button, the respective
s
indicators, [MAX] or [MIN] will be displayed.
s
• To clear the memory, hold the [MEM] button for 3 seconds. The maximum and minimum tempera-
ture records will be erased.
ALARM FUNCTIONS
Weekday Alarm
• This is a repeat alarm that will be activated daily from Monday to Friday at a set time.
Single Alarm
• This is a single alarm that will be activated once at a set time.
Pre-Alarm
• The pre-alarm will be activated and the icon will flash if the temperature of Channel 1 is falling to
+0 °C or below.
• This alarm is programmable 15, 30, 45, 60 or 90 minutes earlier than the weekday alarm or single
alarm.
HOW TO SET THE ALARM
• Press the [SET] button to toggle between weekday alarm, single alarm or pre-alarm.
If the alarm is disarmed, the time will be displayed as "OFF W-ALM"
• Hold the [SET] button for 3 seconds. The hour digits will start flashing.
• Enter the hour by using the [ ▲ ] or [ ▲ ] button.
• Press the [SET] button to confirm, the minute digits will start flashing.
• Enter the minute by using the [ ▲ ] or [ ▲ ] button.
• Press the [SET] button to exit and the respective alarm icons [
activated.
s
icon is displayed, to enable an automatic scan of all
s
38
˚C
˚C
s
s
], [ ] and [
˚C
] will be