salmson LRE Notice De Montage Et De Mise En Service page 79

8.6.2 Changing to menu mode
2 s
ON
1
12.3
Fig. 27: Standard menu mode
2 s
ON
1
12.3
Fig. 28: Service menu mode
E000
Fig. 29: Error case menu mode
8.6.3 Navigation
±
1.0.0.0
±
2.0.0.0
4.0.0.0 4.1.0.0
5.0.0.0 4.2.0.0
4.4.0.0
Fig. 30: Navigation example
Installation and operating instructions LRE-JRE
2 s
• While the display is showing the status page, press the white button
±
2.0.0.0
±
5.0.0.0
±
6.0.0.0
2 s
• Change to menu mode (see 8.6.2 "Changing to menu mode" on
• To select the menu element, turn the white button.
• If the downward pointing arrow for "One level down" is shown, press
4.4.1.0
4.4.3.0
• To return to the next higher menu level, select the "One level up"
To change to menu mode, proceed as follows:
for 2 seconds (except in case of an error).
Standard behaviour:
The display changes to menu mode. Menu number <2.0.0.0> is dis-
played (Fig. 27).
Service mode:
If service mode is activated via DIP switch 1 menu number <5.0.0.0>
is displayed first (Fig. 28).
Error case:
In case of error, menu number <6.0.0.0> is displayed (Fig. 29).
page 72).
Carry out general menu navigation as follows (for an example,
see Fig. 30):
During navigation, the menu number flashes.
The menu number is incremented up or down. The symbol associated
with the menu element and the setpoint or actual value are shown, if
applicable.
the white button to change to the next level down. On the display, the
new menu level is indicated by the menu number, for example,
<4.4.0.0> changes to <4.4.1.0>.
The symbol for the menu element and/or the current value (setpoint,
actual value or selection) is shown.
menu element and press the white button.
On the display, the new menu level is indicated by the menu number,
for example, <4.4.0.0> changes to <4.4.1.0>.
NOTE
If the white button is pressed for two seconds while a "One level up"
menu element is selected, the display jumps back to the status page.
English
72