Belkin OmniView F1DW116C Manuel De L'utilisateur page 10

P74342ea_F1DWXXXC_man.qxd 28-10-2003
INSTALLATION
3. Connect the console monitor, keyboard, and mouse to the console ports of the primary
Switch(es), as previously described for standalone units, skipping steps 5 and 6.
Note: Dual-console support available on 2x16 model only.
4. Connect the computers to the Switch as previously described for standalone Switches.
11:57 Page 14
F1DE101A-AP
F1DE101A-AP
14
INSTALLATION
Connecting the Daisy-Chain Cable:
5. Begin with BANK 00. Using the Daisy-Chain Cable (F1D9402-XX), connect one end
to the "Daisy-Chain OUT" port on the first Switch.
6. Connect the other end of the Daisy-Chain Cable to the "Daisy-Chain IN" port of
the next Switch.
Note: It does not matter which unit is the primary unit, only that they are
connected OUT-to-IN or IN-to-OUT.
Adding Additional Units:
7. Continuing in the same manner, using the Daisy-Chain Cable (F1D9402-XX),
connect "Daisy-Chain OUT" to "Daisy-Chain IN" on all subsequent units.
CAUTION: Never connect "Daisy-Chain IN" to "Daisy-Chain IN" or "Daisy-Chain OUT"
to "Daisy Chain OUT". This may produce unpredictable results.
Example of Daisy-Chain Configuration
Connecting the Computers:
8. Power on the Switches, in any order. You will see the port LEDs flash on and off
and the seven-segment LEDs will light up, displaying a series of diagnostic codes,
eventually stopping with the digits "XX", where XX is its BANK address.
Note: If the Switches still do not enumerate with their corresponding BANK address,
check that all Switches have the correct BANK address assigned to them and that all
daisy-chain cables are connected properly.
15