Güde GADH 254 P Mode D'emploi page 17

Gearbox servicing:
1. Unscrew the gearbox cover cap nuts and both cross
screws.
2. Remove the gearbox cover.
3. Remove wood dust and shavings using the shaving
exhauster or a brush.
4.
Apply the maintenance and treatment spray on the roller
chain and pulley bearings. Never use any grease!
5. Refit the gearbox cover.
Any changes to the surface and thickness planer exclude
liability of the manufacturer for any consequential damage of
any type.
Service
Any technical questions? Complaint? Do you need spare
parts or operation manual?
Go to our website www.guede.com and the section Service
will help you quickly and without bureaucracy. Please, help us
to help you. In order to identify your device in case of
complaint, please indicate serial number, order number and
year of manufacture. All information is available on the
product label. To have all information always at hand, put
them down.
Serial number:
Order number:
Year of manufacture:
Phone: +49 (0) 79 04 / 700-360
Fax: +49 (0) 79 04 / 700-51999
E-Mail: support@ts.guede.com
Failures – causes - remedies
Switch the device off and unplug it before removing any failure.
Failure
Device does not start running
after being switched on or gets
automatically switched off
when running idle
Device stops during planing
Workpiece gets stuck during
thicknessing
Surface condition is
unsatisfactory
Processed surface is too
rough
There are cracks in the
processed surface
Shavings output is blocked
Too small workpiece feed
during thicknessing
Refit and check all the safety equipment after removing any failure!!!
Cause
•
Power failure
• Defective engine or switch
• Worn-out carbon brushes
• Planing knife is blunt
•
Feeding is too big
•
Thermal fuse has been activated
•
Overload protection has been activated
•
Cutting depth is too big
•
Planing knife is blunt
• Planing knife is blocked up with shavings
•
Feeding is irregular
•
Workpiece is too damp
•
Workpiece has been processed against
the direction of growth
• Too much material has been planed away
at one time
•
Exhauster is not connected
•
Wood is too damp
• Resin on the planing table desk
•
Transport cylinders running heavy
•
Pulley is loosened
Optional accessory equipment
Spare HSS planing knives
Art. No. 55055
Waxilit slide spray
Art. No. 55085
Remedy
•
Check the fuse
• Check the cables and replace any defective
ones
•
Have the engine or switch checked or repaired
by a qualified electrician.
• Change or sharpen the knife
•
Continue working at a lower speed of feeding
•
Restart the engine after it has cooled down
•
Check the chain, feed or engine for any
undesirable items.
•
Reduce the cutting depth and process the
workpiece in several steps
•
Change or sharpen the knife
• Remove shavings
•
Feed the workpiece under constant pressure
and at a reduced speed of feeding
•
Dry the workpiece out
•
Process the workpiece in the opposite direction
•
Process the workpice in several steps
•
Switch the device off, remove shavings and
connect the exhauster
• Use dry wood
• Clean the table desk and apply a thin layer of
slide wax on it
•
Adjust the transport cylinders
17