Backrest And Stroller Handle; Stroller Handle Extension; Reclining Back - Quickie SR45 Mode D'emploi

E N G L I S H
13
4. Cable Adjustment
NOTE– Do not use lubricants on the components or assembly.
a. Loosen the jam nut (A).
b. Rotate the cable adjuster (B) until slack is removed from the cable. Make sure the
plunger pin can fully extend and retract after adjustment and that pins engage the rock-
er when triggers are released.
c. Tighten jam nut (A).
H. BACKREST AND STROLLER HANDLE
14
1. Angle Adjustment
a. Loosen rear bolt (C).
b. Loosen and remove angle adjustment bolt (D).
c. Set backrest at desired angle using pre-set holes.
d. Replace and tighten the angle adjustment bolt (D).
e. Tighten rear bolt (C).
f. Repeat on other side.
IMPORTANT NOTE– The adjustment on each side of the chair should be exactly equal.
NOTE– Use a torque setting of 120 in.-lbs. When setting-up the angle adjustment of the stroller handle.
NOTE– Backrest position may also need adjusting to maintain optimal CG alignment and stability.
2. Angle Adjustment of the Stroller Handle (optional)
Depress both black push buttons (E) at the same time. This disengages the stroller handle and
allows it to rotate freely. Releasing the push buttons positively locks the adjustable stroller han-
dle in the desired position.
3. Height Adjustment (optional)
a. Remove both bolts (F) from the backrest tube (one on each side).
b. Reposition backrest height.
c. Re-tighten both bolts (F) in the desired location.
NOTE– Both sides must be at the same height.
NOTE– It is not recommended to align the top hole in the lower tube with the bottom hole in the upper
tube, as excess play may result.
4. Flip-Down Back Function
a. To fold the back down, pull-up the back release pins (G) and push the backrest for-
ward.
b. To lock it back in position, lift the backrest firmly until it locks in its original position.
I. STROLLER HANDLE EXTENSION
17
Installation
a. Press button (H) simultaneously on both sides of the stroller handle so that release pins
are drawn inside the tube.
b. Insert the tube into the back tube receiver (I) until the release pin protrudes through
the receiver mounting hole.
J. RECLINING BACK
The dual trigger reclining mechanism is installed by Sunrise Medical.
To Recline or Raise Backrest
a. Depress both triggers (A) at the same time. Releasing the triggers positively locks the
backrest in place.
b. To lock out the adjustment system, insert the locking pin (B) into the trigger holder.
Always lock the dual trigger reclining mechanism securely in place after positioning the
backrest.
118611 Rev. B
15
15
16
(optional)
(optional)
(optional)
18
16
IX. SET-UP & DJUSTMENT
13
A
B
14
C
D
15
F
E
16
G
17
I
H
18
A
B