Battery Removal; Folding Backrest; Swing-Away Footrests - Quickie SOPUR P-220 Manuel D'utilisation Et Garantie

I X . S e t - u p , A d j u s t m e n t s a n d U s e
A. POWER DRIVE UNIT
Wheelchair and power drive attachment
a. Position seat and main frame over power drive unit.
b. Align quick-connect blocks (A) with binding socket (B) located on power drive unit.
c. Ensure frame is properly located on power drive unit and the controller cable is clear.
d. Press levers (C) down until locked.
e. Lever force required can be adjusted by adjusting screw.
Always secure levers before operating chair. If the chair fails to operate and the
battery charge indicator flashes 9 bars, check both quick-connect levers for
securement. Then cycle the on/off switch.
B. BATTERY REMOVAL
To remove the batteries for transporting or servicing:
Remove batteries
a. Remove seat and main frame from power drive unit using quick-release levers shown
above (C).
b. Remove battery compartment lid by releasing the two (2) quarter turn fasteners.
c. Prevent the power drive unit from tipping forward by placing a solid object under-
neath the front of the power drive unit.
d. Lift battery compartment (E) off the power drive unit.
e. Disconnect battery leads from power harness.
f. Lift rear-most battery out using the battery straps (F).
g. Pull the front battery backwards, disconnect it, and remove it using the battery straps.
Batteries may weigh up to 25 kg. Care must be taken to avoid injury when lifting.
C. FOLDING BACKREST
Quickie/Sopur P-220 wheelchairs are shipped with backrest in folded position.
1. Upright positioning
a. Lift backrest to upright position so that latch handles (A) lock into place.
b. Backrest is ready for use.

2. Folding backrest

a. Lift and turn backrest latch handles (A) inward or outward.
b. Fold backrest forward.
CAUTION: Backrest latches must be locked into place before operating wheelchair.
D. SWING-AWAY FOOTRESTS
1. Installation
a. Place swing-away pivot pin (B) into the locating hole (C) on top of the hanger mount
with the footrest facing outward from frame.
b. Rotate the footrest inward until latch plate locks (D) into place on locking bolt.
2. Removal
a. To remove footrest, press quick-release lever (E).
b. Rotate footrest outward and lift.
3. Height adjustment
a. Loosen all four (4) set screws (F) in the hanger frame tube.
b. Reposition footrest height.
c. Retighten all set screws (F).
All manuals and user guides at all-guides.com
E n g l i s h
A
B
C
C
E
F
A
B
C
D
E
F
21
930479 Rev. C