Folding Backrest - Quickie Neon2 Manuel D'utilisation

6.6 Backrest
To adjust the back angle, please undo the Allen screw (1) and remove
it. Set the desired position and then refit the Allen screw in this
position and tighten it to the given torque (Fig. 6.6.1).

Folding backrest

To make it easier to transport the wheelchair, the top half of the
backrest can be folded down.
To do this, press both levers (1) and fold the backrest down. When
folding the backrest back up, please make sure that both sides are
firmly interlocked (Fig. 6.6.2/6.6.3).
WARNING!
• Risk of injury: do not get your fingers caught in the folding back
mechanism.
CAUTION!
Please take into account the altered centre of gravity
when setting the angle of the backrest, , tension of the backrest belts
or backrest height. This may lead to an unstable wheelchair likely to
tip and may rquire the use of anti-tip tubes.
Adjustable back-sling
The adjustable back-sling can be adjusted for tension by using
several straps. (Fig. 6.6.4).
NEON 2 SA
Fig. 6.6.1
1
Fig. 6.6.2
Fig. 6.6.3
Fig. 6.6.4
26
1
Rev.B