Set-Up & Adjustment; Swing-In/Swing-Out Hangers And Footrests; Elevating Legrest - Quickie SR45 Mode D'emploi

E N G L I S H
NOTE– Setting the wheelchair on a table or on a flat surface, such as a workbench, helps make these proce-
dures easier.
NOTE ON TORQUE SETTING– A torque setting is the optimum tightening which should be made on a
particular fastener. A torque wrench which measures in./lbs. should be used when tightening fas-
teners on Quickie wheelchairs. Unless otherwise noted, use a torque setting of 60 in./lbs. When
setting up this wheelchair.
A. SWING-IN/SWING-OUT HANGERS AND FOOTRESTS
1 2
(70º, 80°)
1
1. Installation
a. Place swing-in/swing-out pivot saddle into the receiver on front frame tube with the footrest
facing inward or outward from the frame. (
b. Rotate the footrest inward until it locks into place on locking bolt. (
2. Removal
a. To remove footrest, release latch by pulling lever upward or pushing lever downward.
b. Rotate footrest inward or outward and lift.
2
3. Height Adjustment
NOTE– It is recommended that you maintain a minimum of 2.0 inches between the lowest point on the
footrest and the floor.
a. Loosen set screw (C) using a 3/16 inch hex key.
b. Slide footrest extension up or down inside frame tube to desired height.
c. Tighten set screw. Use a torque setting of 144 in-lbs (16.27 Nm).
B. ELEVATING LEGREST
1. Installation or Removal
To install or remove Elevating Legrest (ELR) see instructions for Swing-away Footrest
installation.
2. Elevation Adjustment
a. To raise legrest, lift to desired position. Legrest will automatically lock in place.
b. To lower legrest, while seated in chair, press release lever (G) down and lower legrest
to desired position. Legrest will automatically lock in place.
3. Height Adjustment of the Calf Pad
a. Loosen the retaining nut (H) located at the back of the calf pad bracket assembly.
b. Slide the calf pad bracket assembly up or down.
c. Tighten it in the desired position.
4. Height Adjustment with Extension Tube
NOTE– It is recommended that you maintain a minimum of 2.0 inches between the lowest point on the
footrest and the floor.
a. Loosen set screw (I) using a 3/16 inch hex key.
b. Slide footrest extension up or down inside frame tube to desired height.
c. Tighten set screw. Use a torque setting of 144 in-lbs (16.27 Nm).
1
-A)
1
3
(optional)
-B)
backside view
13
IX. SET-UP & DJUSTMENT
1
A
B
2
C
3
G
H
I
118611 Rev. B