Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
The BENNING IT 105 installation tester is a multifunctional tester for testing electrical installations in com-
pliance with IEC 60364-6 (DIN VDE 0100-600) and EN 50110 (DIN VDE 0105-100).
The device is intended for the following measurements and tests:
-
voltage, frequency and rotary field (phase sequence)
-
low-impedance resistance (R
-
insulating resistance (R
-
residual current protection devices (RCD
-
loop impedance (Z
-
loop impedance (Z
-
Loop impedance (Z
(PFC) and short-circuit current (PSC)
Contents
1.
User notes
2.
3.
4.
5.
6.
7.
8.
8.1
8.1.1
8.1.2
8.1.3
8.2
8.3
8.4
8.5
8.5.1
8.5.2
8.6
8.6.1
8.6.2
8.6.3
9.
10.
1. User notes
This operating manual is intended for qualified technical personnel! Qualified technical
personnel is competent to identify risks and to prevent possible hazards. Improper han-
dling involves the risk of injury!
Warning of electrical danger!
Absolutely observe all safety instructions!
Always observe international, national and - if applicable - regional regulations of electrical engineering.
Relevant knowledge of electrical engineering is absolutely required.
The BENNING IT 105 is intended for making measurements in dry environment (more details in section
6. "Ambient conditions").
The following symbols are used in these operating instructions and on the BENNING IT 105:
11/ 2018
Operating manual
BENNING IT 105
) with a testing current of 200 mA
LOW
) with testing voltage of 250/500/1000 V
ISO
) without RCD tripping
LOOP
)/line impedance (Z
S
I
)/ line impedance (Z
S
)
), (RCD
)
t
I
)
) with high testing current and calculation of the fault current
I
)
BENNING IT 105
15
Publicité
Chapitres
Table des Matières
