ACCESSORIES
MOUNTING BRACKETS
Heavy gauge steel bracket for vertical or horizontal
10-12360
mount on either front or top of coil on a rolling door.
Has a variety of mounting hole patterns compatible
with many OEM manufacturers. For use with J, H, DJ,
and DH operators. May be welded.
08-9098
Cast iron bracket to mount J, H, DH, DJ, and GH side
mount operators on end bracket of a rolling door or
grill. For vertical or horizontal mount on either front or
top of coil. Cannot be welded.
Same as 08-9098, but with adapter plate to hold
08-9098EZ
mounting bolts in place for easy mounting.
Heavy gauge steel bracket for vertical or horizontal
1A4324
mount on either front or top of coil on a rolling
door. May be welded. For use with J, H, DJ, and DH
operators.
Same as 1A4324, but with adapter plate to hold
1A4324EZ
mounting bolts in place for easy mounting.
CHAIN TENSIONERS
71-6023
For 1" (2.5 cm) shafts. Recommended to properly
tension drive chain between operator shaft and
door shaft.
Same as 71-6023, but for 1-1/4" (3.2 cm) shafts.
71-6125
OPTION CARDS
Timer Light Status Card:
TLS1CARD
The TLS option card provides special functionality
to activate and fl ash auxiliary devices such as
lights, bells, and horns/strobes at various door
positions, and to provide special timer functions.
Auxiliary Contact Card:
AUXCARD
The Auxiliary Contact option card has both Normally-
Open and Normally-Closed contacts that actuate
when the door is idle, opening, or closing.
For Jackshaft Type Operators
53
ADDITIONAL CONTROL ACCESSORIES
86LM (15' [4.6 m])
Antenna Extension Kit:
86LMT (25' [7.6 m])
The antenna extension kit can be used with EXT-ANT
for maximum radio receiver range.
RGL24LY
Red/Green Traffic Light:
Indicates when a commercial door reaches the
open position. Provides assurance of safe entering
and exiting of the facility, reducing the potential for
costly accidents. (TLS1CARD is recommended)
50-HERK2
Motion Detector 24V
Microwave motion detector with two independently
programmable channels.
50450
Switch Sectional Door Interlock
NEMA 4 switch disables operator control circuit
when door is locked preventing electrical operation
of the door.
Accessories