LiftMaster Elite Serie Instructions D'installation

WARNING: This product can expose you to chemicals including lead, which
are known to the State of California to cause cancer or birth defects or other
reproductive harm. For more information go to www.P65Warnings.ca.gov.
APPLICATION
ENGLISH WARNINGS AT 50%
The heater keeps the gearbox and batteries at a suitable temperature when
the outside temperature is below -4°F. The thermostat MUST be set
between 45°F and 60°F to ensure proper gate operation. The heater can be
powered by 110 to 250 VAC.
INSTALLATION
(MODEL HDSW24UL, HDSL24UL IHSL24UL, INSL24UL)
1. Fasten the heater bracket to the operator with the provided hardware.
NOTE: The location for the heater will vary. Refer to the illustration to
find the location of the heater on the operator
NOTE: INSL4UL/IHSL24UL require additional bracket, refer to illustration.
2. Attach the heater and thermostat to the heater bracket by sliding the
top clips onto the bracket, then push down until the bottom clips snap
onto the bracket.
3. Route the heater wires to the power wires on the operator, securing the
wires with the provided wire clips:
FRENCH WARNINGS AT 50%
Model HDSL and HDSW: Chose the appropriate-sized knockout on the
junction box and install the watertight connector. Insert the heater
wires through the watertight connector.
Model INSL24UL and IHSL24UL: Chose the appropriate-sized knockout
on the junction box and install the connector. Insert the heater wires
through the connector.
4. Connect the heater wires to the power wires of the operator with the
provided wire nuts.
NOTE - HDSL24UL/HDSW24UL and INSL24UL/IHSL24UL models have
wires marked "HEATER", connect to these wires.
5. HD models only – slide the battery bracket back into place and secure.
6. Set the thermostat dial between 45°F and 60°F.
7. Reconnect power to the operator.
Thermostat
Top Clip
SPANISH WARNINGS AT 50%
Heater Bracket
1/2" minimum
Heater
distance
HEATER KIT
To prevent SERIOUS INJURY or DEATH:
• Disconnect electric power to operator BEFORE installing
or servicing.
• The heater gets extremely hot during operation. DO NOT
touch the heater while it is in operation. Allow 15 minutes
for the heater to cool before servicing the operator.
MODEL IHSL24UL, INSL24UL
Bracket
Heater Bracket
Thermostat
MODEL HDSW24UL
MODEL HDSL24UL
MODEL HTR
Electrical Box
Heater
Heater Bracket
Thermostat
Heater
NOTE: The heater should
be near the motor.
Heater Bracket
Thermostat
Heater
NOTE: The heater should
be near the motor.