Safety Information - LiftMaster Elite Série Manuel D'installation

SAFETY INFORMATION

When you see these Safety Symbols and Signal Words on the
following pages, they will alert you to the possibility of serious
injury or death if you do not comply with the warnings that
accompany them. The hazard may come from something
mechanical or from electric shock. Read the warnings carefully.
When you see this Signal Word on the following pages, it will
alert you to the possibility of damage to your door and/or the door
operator if you do not comply with the cautionary statements that
accompany it. Read them carefully.
IMPORTANT INSTALLATION INSTRUCTIONS
TO REDUCE THE RISK OF SEVERE INJURY OR DEATH:
1. READ AND FOLLOW ALL INSTALLATION WARNINGS AND
INSTRUCTIONS.
2. Install door operator ONLY on a properly balanced and
lubricated door. An improperly balanced door may NOT
reverse when required and could result in SEVERE INJURY
or DEATH.
3. ALL repairs to cables, spring assemblies and other hardware
MUST be made by a trained door systems technician BEFORE
installing an operator.
4. Disable ALL locks and remove ALL ropes connected to a
door BEFORE installing an operator to avoid entanglement.
5. Install an operator, a minimum of 8 feet (2.44 m) from the
floor.
6. NEVER connect a door operator to a power source until
instructed to do so.
7. NEVER wear watches, rings or loose clothing while installing
or servicing an operator. They could be caught in the door or
operator mechanisms.
Mechanical
Electrical
IMPORTANT NOTES:
• BEFORE attempting to install, operate or maintain the
commercial door operator, you must read and fully understand
this manual and follow all safety instructions.
• DO NOT attempt repair or service of a commercial door
operator unless you are an Authorized Service Technician.
• A commercial door operator should only be installed on a
properly balanced door only. Ensure door is properly balanced
prior to installation.
WARNING
ENTRAPMENT PROTECTION DEVICES:
LiftMaster Monitored Entrapment Protection (LMEP)
Monitored photoelectric sensors and/or door edge sensors
are required for any momentary contact to close modes of
operation. See pages 20-21 for additional information. Refer to the
accessories page 51, 'Entrapment Protection Devices' for available
options.
WARNING
WARNING: This product can expose you to chemicals
including lead, which are known to the State of California to
cause cancer or birth defects or other reproductive harm.
For more information go to www.P65Warnings.ca.gov
WARNING WARNING
8. Install a control station:
• within sight of the door
• out of reach of children and at a minimum height of
5 feet (1.5 m)
• away from ALL moving parts of the door
9. Install the control station far enough from the door to
prevent the user from coming in contact with the door while
operating the controls.
10. Install the entrapment warning placard on the wall next to
the control station in a prominent location, visible from the
door.
11. Place the manual release/safety reverse test label in plain
view on the inside of door.
12. Upon completion of installation, test the entrapment
protection device(s).
13. This door operator is not intended to replace door locks.
With enough force, a door without a door lock can be
opened. LiftMaster always recommends the use of door
locks to properly secure a door.
SAVE THESE INSTRUCTIONS.
14.
3 Safety Information