Description Of The Remote Control Commands - Metrohm 756/831 KF Mode D'emploi

4.2.2 Description of the remote control commands

756/831 KF Coulometer, Instructions of Use
4.2.2.1. Mode
Start and stop ($G, $S) of the current method (4.2.2.3)
$G also serves to continue after inquiries of identifications and sample size after the
start (see 4.2.2.15)
4.2.2.2. Mode.Select
Selection of the standard mode.
If a method is selected from the method memory, the node &Mode.Select is over-
written with the mode of the corresponding user method.
4.2.2.3. Mode.Name
Name of the current method in the working memory. $Q sends 8 ASCII characters.
Standard methods carry the name ********. The node can be set read + write,
see 4.2.2.66.
4.2.2.4. Mode.Parameter.CtrlPara.EP
Setting of the EP in mV.
4.2.2.5. Mode.Parameter.CtrlPara.Control
Mode.Parameter.CtrlPara.Special.Dyn
Mode.Parameter.CtrlPara.Special.MaxRate
Mode.Parameter.CtrlPara.Special.MinRate 0.3...15...999.9, min.
Mode.Parameter.CtrlPara.Special.Stop.Type
Mode.Parameter.CtrlPara.Special.Stop.Drift
Mode.Parameter.CtrlPara.Special.Stop.Drift
Parameters for setting "special" (4.2.2.5):
.Dyn: Dynamics in mV.
.MaxRate: Maximum allowed titration rate in ug/min. Max. means maximum possi-
ble rate.
.MinRate: Minimum titration rate in ug/min.
.Type: Type of stop criterion after drift or switch-off delay time.
.Drift: Stop drift in ug/min. Applies when "drift" has been selected.
.RelDrift: Relative stop drift in ug/min. Applies when "rel.drift" has been selected.
Stops if the drift reaches the current drift at the start of the method plus
the rel.drift value.
4.2.2.6. Mode.Parameter.TitrPara.Direction
Titration direction.
"auto" means the titration direction is determined automatically by the instrument.
4.2.2.7. Mode.Parameter.TitrPara.Pause
Mode.Parameter.TitrPara.ExtrT
4.2 Remote control commands
$G, $S
KFC, KFC-B, BLANK, GLP
read only
0...50...±2000
content, special
1...70...2000
1.5...2240, max.
drift, rel.drift
1...5...999
0...5...999
+, -, auto
0...999 999
0...999 999
75