Installation And Setting - Meister WS500-115M Mode D'emploi

„Tested Safety" voluntary
quality mark
Housing is double insulated
CE Mark (conformity to
European safety standards)
Disk size 115 mm / Joining
Ø 115 mm
thread M14
M14
BJ Year of construction
SN: Serial number
SN: XXXXX The first two underlined
numbers give the month of
manufacture.
7 – Installation and setting
Disk guard
The position of the disc cover (3) can
be adapted to suit the relevant working
conditions. To do this, loosen the
screw (11) with a screwdriver and turn
the cover to the new position. Tighten
the screw back up again (fig. 3).
The closed disc cover included in the
scope of delivery for this article is
designed for separating discs only.
CAUTION! The closed part of the
disk guard should always point
towards the user to protect him from
sparks and chippings.
Mounting and removing the disc cover
If necessary and if the situation requires,
the disc cover can be removed com-
pletely. To do this, loosen the screw
(11) in such a way that the cover can be
5405070-Winkelschleifer-man.indd 59 5405070-Winkelschleifer-man.indd 59
removed by turning it out of the guide
groove of the grinding head.
To mount the disc cover, follow instruc-
tions in reverse order.
Mounting tools
CAUTION! Before working on the
machine, always pull out the
power plug!
Separating discs, grinding and
roughing discs
All types of grinding and separating
discs can be mounted to the spindle (4)
(Figure 2) (offset A/B, flat). Depending
on the type of disc and the thickness,
a suitable arrangement of the tension-
ing disc (9) and the clamping nut (8) is
selected
Press the spindle-locking button
(5) in deep and hold it in this posi-
tion. If necessary, turn the spindle
slightly with the free hand until it locks
into position. Tighten the clamping nut
with the flange key provided (fig. 6). Do
not work with disks thicker than 6 mm.
CAUTION! Allow disks to cool
down before changing them.
HOT! Always work with the disk guard
in position!
CAUTION! With accessories,
always comply with the
manufacturer's directions. The
maximum rotation speed must be
greater than the idling speed of the
machine.
Additional grip
The additional handle (2) can, depending
on the way in which you are working, be
59
22.10.20 10:52 22.10.20 10:52