Installation And Setting - Meister MWS900-125 Traduction Du Manuel D'utilisation Original

5455200-Winkelschl_man 08.05.15 13:07 Seite 58
Use ear defenders
„Tested Safety" voluntary
quality mark
Housing is double insulated
CE Mark (conformity to
European safety standards)
7 – Installation and setting
Disk guard
The scope of the delivery for this power
tool contains a protective hood for
cutting discs (3) and one for roughing
discs (12).
The position of the disc covers (3/12)
can be adapted to suit the relevant
working conditions. To do this, loosen
the screw (5) with a screwdriver and
turn the cover to the new position.
Tighten the screw back up again (fig. 3).
CAUTION! The closed part of the
disk guard should always point
towards the user to protect him from
sparks and chippings.
Mounting and removing the disc
cover
If necessary, and if the situation requires it,
the disc cover can be exchanged. To do
this, loosen the screw (5) in such a way
that the cover can be removed by turning
it out of the guide groove of the sanding
head.
Mount in reverse order.
58
Mounting tools
CAUTION! Before working on the
machine, always pull out the
power plug!
Separating and roughing discs
All types of separating and roughing
discs can be mounted to the spindle (4)
(Figure 2) (offset A/B and flat).
Depending on the type of disc and the
thickness, a suitable arrangement of
the tensioning disc (7) and the clamping
nut (8) is selected
Press the spindle lock button (6)
in deep and hold in position. If
necessary, rotate the spindle
with your spare hand until it clicks into
place. Then tighten the clamping nut
back up again with the supplied
flange wrench (Figure 5). We do not
recommend using discs thicker than
6 mm.
CAUTION! Allow disks to cool
down before changing them.
HOT! Always work with the disk guard
in position!
CAUTION! With accessories,
always comply with the
manufacturer's directions. The
maximum rotation speed must be
greater than the idling speed of the
machine.
Additional grip
Depending on the working method, the
additional handle (10) can be mounted
in three different positions on the
grinding head (fig. 4).