Meister WS500-115M Mode D'emploi page 53

f Dress properly. Do not wear loose
clothing or jewellery. Keep your hair,
clothing and gloves away from mov­
ing parts. Loose clothes, jewellery
or long hair can be caught in moving
parts.
g Keep handles dry, clean and free from
oil and grease. Slippery handles do not
allow for safe handling and control of
the tool in unexpected situations.
h If devices are provided for the con­
nection of dust extraction and col­
lection facilities, ensure these are
connected and properly used. Use
of these devices can reduce dust
related hazards.
4 Power tool use and care
a Do not force the power tool. Use
the correct power tool for your
application. The correct power tool
will do the job better and safer at the
rate for which it was designed.
b Do not use the power tool if the
switch does not turn it on and off.
Any power tool that cannot be con-
trolled with the switch is dangerous
and must be repaired.
c Disconnect the plug from the
power source before making any
adjustments, changing accessories,
or storing power tools. Such preventive
safety measures reduce the risk of start-
ing the power tool accidentally.
d Store idle power tools out of the
reach of children and do not allow
persons unfamiliar with the power
tool or these instructions to operate
the power tool. Power tools are dan-
gerous in the hands of untrained users.
5405070-Winkelschleifer-man.indd 53 5405070-Winkelschleifer-man.indd 53
e Maintain power tools. Check for
misalignment or binding of moving
parts, breakage of parts and any
other condition that may affect the
power tool's operation. If damaged,
have the power tool repaired before
use. Many accidents are caused by
poorly maintained power tools.
f Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to
bind and are easier to control.
g Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking into
account the working conditions and
the work to be performed. Use of
the power tool for operations different
from those intended could result in a
hazardous situation.
5 Service
a Have your power tool serviced
by a qualified repair person using
only identical replacement parts.
This will ensure that the safety of the
power tool is maintained.
II. Safety notes for all applications
General warnings with regard to abra-
sive cutting and roughing:
a This electrical tool is to be used
as a grinder and cutting device.
Pay attention to all of the warning
notes, instructions, diagrams
and data you receive with the unit.
If you do not observe the following
instructions, it may lead to electrical
shock, fire and/or serious injuries.
b This electrical tool is not suitable
for sandpaper sanding, working
with wire brushes, polishing. Uses
53
22.10.20 10:52 22.10.20 10:52