Dyson 360 Eye Mode D'emploi page 31

downloading an update via your computer. See
'Software updates' section.
DISABLE WI-FI
• Your robot is automatically set to send out a wi-fi signal
that can be picked up as a local network (also called
'AP' mode.) If desired this mode can be switched 'OFF'
by following the instructions below.
• Download the 'Disable wi-fi mode' software from
the Dyson website on to a USB stick. Make sure this
software is the only item on the USB stick and the stick
has at least 256MB of free space.
• Remove the post filter and filter cover and insert the
USB stick into the USB port.
Manually replace the robot on a powered dock and
ensure it is charging.
• Press the power button until a ring of pink lights flash,
then release the button. The software will automatically
switch 'OFF' wi-fi mode.
• Once complete the robot will turn off.
• Remove the USB and replace the filter and filter cover.
The robot is now ready to use as normal.
ENABLE WI-FI
• If you want to enable the robot to emit a wi-fi signal
again, follow the same steps as above but instead
download the 'Enable wi-fi mode' software from the
Dyson website.
RESETTING THE ROBOT
• If ownership of the robot changes, you may wish to
reset the robot so that home network names and
passwords are cleared.
• To reset the robot, follow the same steps as the 'disable
wi-fi' section but instead download the 'reset robot'
software from the Dyson website.
BATTERY SAFETY INSTRUCTIONS
• If the battery needs replacing please contact the
Dyson Helpline.
• The battery is a sealed unit and under normal
circumstances poses no safety concerns. In the unlikely
event that liquid leaks from the battery do not touch the
liquid and observe the following precautions:
• Skin contact – can cause irritation. Wash with soap
and water.
• Inhalation – can cause respiratory irritation. Expose to
fresh air and seek medical advice.
• Eye contact – can cause irritation. Immediately flush
eyes thoroughly with water for at least 15 minutes. Seek
medical attention.
• Disposal – wear gloves to handle the battery and
dispose of immediately, following local ordinances
or regulations.
CAUTION
• The battery used in this appliance may present a risk of
fire or chemical burn if mistreated. Do not disassemble,
short contacts, heat above 60°C (140°F), or incinerate.
Replace battery with a Dyson battery only: use of any
other battery may present a risk of fire or explosion.
Dispose of used battery promptly. Keep away from
children. Do not disassemble and do not dispose of
in fire.
DISPOSAL INFORMATION
• Dyson products are made from high grade recyclable
materials. Recycle where possible.
• The battery should be removed from the product
before disposal.
• Dispose of the battery in accordance with local
ordinances or regulations.
DYSON CUSTOMER CARE
THANK YOU FOR CHOOSING TO BUY A
DYSON APPLIANCE
If you have a question about your Dyson appliance, call
the Dyson Helpline with your serial number and details
of where and when you bought the appliance. Most
questions can be solved over the phone by one of our
Dyson Helpline staff.
If your Dyson appliance needs service, call the Dyson
Helpline so we can discuss the available options. If your
Dyson appliance is under warranty, and it is a covered
repair, it will be repaired at no cost. Your serial number
can be found on your rating plate which is on the main
body of the appliance.
PLEASE REGISTER AS A DYSON
APPLIANCE OWNER
To help us ensure you receive prompt and efficient
service, please register as a Dyson appliance owner.
There are three ways to do this:
• Online at www.dysoncanada.ca
• Telephone the Dyson Helpline at 866-861-2558
• Complete the enclosed Warranty Form and mail it to us.
This will confirm ownership of your Dyson appliance in
the event of an insurance loss, and enable us to contact
you if necessary.
31