Dyson 360 Eye Mode D'emploi page 25

Post-motor filter
Wash the post-motor filter at least every month according
to the instructions below to maintain performance.
1
Press in the filter release button and
slide the filter cover up.
Remove the post-motor filter.
2
Wash the filter with cold water only.
No hot water and no detergents.
Shake the filter to remove debris and
excess water.
Repeat the wash/shake cycle until the
water runs clear.
Go to
www.dysoncanada.ca/support/robots
3
Allow to completely dry naturally
(24 hours minimum).
To refit: allign the tabs on the bottom of
the filter with the slots on the robot, then
push the top of the filter into place. Slide
the filter cover downwards.
24
hrs
25